MIDIROCK.XYZ
Clock & triggers reference

Moog DFAM Clock & triggers

Look up Moog DFAM starting-step, external-trigger and ADV/CLOCK guidance. This is a clock-and-trigger reference, not a MIDI implementation chart.

Published by MIDIrock.xyz · About Pete and the site · Page updated

Model scopeDFAM patchbay clock and trigger behavior, based on Moog support articles. This is not a MIDI implementation chart or a tested MIDI-to-CV conversion guide. Only sourced values are shown. Check each claim’s verification state before relying on it.

Quick reference

External clock
ADV/CLOCK is the documented external-clock input.
Manufacturer documented
ADV/CLOCK input
Starting on step 1
Highlight step 8 before starting.
Manufacturer documented
Step 8 example
External-trigger check
Raise the selected step's velocity if triggering produces no sound.
Manufacturer documented
Selected-step velocity check

Preparing the starting step

Manufacturer documented

The sequencer begins on the step after the highlighted one. To begin at step 1, prepare it with step 8 highlighted before pressing RUN.

External triggering

Manufacturer documented

If the sequence plays but an external controller does not produce sound, check the selected step's velocity. Moog specifically advises raising that step's velocity.

External clock input

Manufacturer documented

Moog identifies ADV/CLOCK as the input for external clock. Consult the source equipment's documentation before making a patch; this reference does not establish voltage or converter compatibility.

Browse DFAM fixes

References

Sources & review

Sources reviewed: . Documentation does not replace a physical hardware test.

Sections reviewed: ADV/CLOCK input; Step 8 example; Selected-step velocity check; Starting-step explanation and step 8 example.